Outside door handles

[Rickv]

Well , I have another new bee question . My outside doorhandles and bases are toast ,bubbling, peeling ,nasty chrome . Does anybody reproduce these and or , does anyone have a nice pair they are looking to re home? If they are badly pitted are they worth having them rechromed ? I really appreciate the great info I've been getting of this page . You guys are the best , thanks in advance !

[jdsnoddy]

Your best course is to have them rechomed.
Because parts are scarce/expensive, your first course of action should be to refurbish what you have.

[Rickv]

Any chrome shop recommendations John ? So no one repops them ? I'm thinking where I'm at , California chrome work is outrageous .

[jdsnoddy]

Rick:
Here are the recommended forum vendors
https://www.markiiforum.com/showthre...s-and-Services
I think Barry Wolk may have replated some of his things by himself. Just depends your interest/skill level.

[Milsteads Garage]

There is only one good chromer I know of and that’s Royal plating in Tucson Az. I believe they can fix pits in pot metal but you might want to ask.

[Knickoliss Iv]

These guys do amazing work. Expensive but very good. They will quote your parts with photographs. Regardless who does them, make sure they know the difference between filling the pits in and grinding them out. The squareness of the castings can be easily lost by a chromer trying to grind out pits.
https://customplatingspecialist.com/...C-xbxE7mAmaUTg

[Barry Wolk]

Rick:
Here are the recommended forum vendors
https://www.markiiforum.com/showthre...s-and-Services
I think Barry Wolk may have replated some of his things by himself. Just depends your interest/skill level.

I only do zinc-plating like that used on many Mark II copper and steel tubing and fittings. It's very soft. Chrome plating is far more dangerous, health-wise, so I don't do it.

There's a lot to plating automotive chrome. Anyone can dip parts into tanks of chemicals and electricity, but the real work is in the prep. Yes, big pits must be filled with copper and sanded smooth before re-plating can begin. This is the step many tips overdo, leading to "fat" parts that just don't fit anymore. Door handle pushbuttons are a great example of one part needing to fit inside another.

At the last minute before sending the Ruxton to Pebble I found out that the hub caps were not fitting in the metal hubs. The hubs had been plated with way too much copper and the caps would not snap in. I found out how hard chrome really is.

IMG_3023.jpg

IMG_3025.jpg