Originally Posted by
Pat Marshall
Very Good Barry! A few questions -
How thick is the metal (aluminum?) sheeting?
What adhesive (or other method) was used to attach the leather to the metal? The metal to the cardboard?
How were the rectangular holes punched/cut into the metal sheeting.
What did I forget to ask, but should have?
Thanks,
Pat
Due to its location I used stainless steel about the thickness of a paper clip. I used stainless because aluminum with steel fasteners will corrode, especially in a damp area. I used 3M trim adhesive and left it clamped overnight. The dog leg seals are the reason these get destroyed. The factory did a very poor job if sealing under the seals which lets everything seep under the seal. They did a lousy job on the hood seal, too. On an original car there were just dabs of sealant, nothing continuous. My machine shop used a punch on the holes, but I've made them with a drill and a file.
Barry Wolk
Farmington Hills, MI
C5681126