wheel covers

[arkusvt]

unquestionably the most difficult I've ever encountered to install. if there is a trick to installation I certainly would be very appreciative to learn it. mine are not warped, they lay perfectly on a flat surface. what am I missing? thanks for any help.

[Barry Wolk]

Be glad they’re tight. They are tough to install.

[Mark Norris]

unquestionably the most difficult I've ever encountered to install. if there is a trick to installation I certainly would be very appreciative to learn it. mine are not warped, they lay perfectly on a flat surface. what am I missing? thanks for any help.

Yes, mine require a good hard thump with the heel of the hand to get them seated.

[Shelly Harris]

Wearing rubber sole shoes.. like a tennis shoe.....
Start the cover on the left edge so it it stays up on its own in the wheel.
Sit down on the pavement facing the wheel.
Place left foot on the left front side of the cover holding it firmly IN the wheel.
Leaning a bit back holding the disk in with your left foot....., Use your right foot .... SMACK the right side of the cover into the right front of the wheel.

[Joseph Stebbins]

OK this sounds like it was perfected after a large number of installations. Next time I install them with the car on the ground I will try it. I otherwise use a soft rubber mallet...

Biggest tip i can give is from Barry's posts on installing a tall metal air filler stem on the rim and put a short piece of rubber hose on it to keep the little ba*tard from rotating and coming off (as much.)

[arkusvt]

After reading a number of comments on the forum going back several years I decided to purchase new rims and tires. Could not determine what color to paint the rims. the ones on the car appear to be body color. Could anyone confirm that is correct? Thank you, George Perry

[jdsnoddy]

Correct. The standard was body color. Some had DSO which could have been another color such as red or black.