Chassis drains

[Barry Wolk]

While washing the chassis before reinstalling the engine and trans I found 3 tubular crossmembers with drain holes plugged completely with nesting material.

The front crossmember, behind the bumper, only has a slight dip to it, but it holds a considerable amount of water when the drain hole in the center is plugged.

The second crossmember, under the engine, was also plugged. Very little nesting material came out, mostly dried grass.

You might want to check the drain holes all over the chassis. In the lighting business for 40 years I've seen rust eat through 8 gauge steel and topple a 40-foot pole.

https://hosting.photobucket.com/images/gg18/barry2952/296_rolling_frame.jpeg

I also found that the core support has no drainage at all. This car has a rubber spacer that stops water from exiting out the elongated holes that hold the core support, which carries the entire weight of the sheetmetal and grill of the front end. This is where you adjust front fender to door gaps. If these bolts have been tightened too much or the rubber has lost its shape you might want to check this, and the drain holes all over the chassis. I'll see if I can chart them.

I just gave the water someplace to go with a 1/4" hole on either side of the support bolts. Something we did to every light fixture we installed over 40 years. You can't keep water out, you simply have to give it someplace to go.

https://hosting.photobucket.com/images/gg18/barry2952/IMG_3438.jpeg

[Barry Wolk]

In my search for drain holes there are none where there should be.

The boxed frame rails are simple [ ] pieces that slip into each other, overlapping top and bottom. They are stitch-welded, normally used to prevent warping from the heat of continuous welds. When new the metal lay flat, but not perfectly sealed. Water would splash up onto the frame and enter the unsealed overlap.

This is from an area ahead of the rear wheels. Note how flat the seams are.

https://hosting.photobucket.com/images/gg18/barry2952/IMG_3441.JPG

This is the frame just behind the front wheel, where the frame would stay wet driven in the rain or snow.

This is evidence of rust blooms expanding and literally stretching and bending the metal between welds. Using a very thin gauge I could not get into any gap more than 1/8". Solid rust

https://hosting.photobucket.com/images/gg18/barry2952/IMG_3442.JPG

This, I believe, is critter damage. This appears, to me, to have rusted from the inside-out.

https://hosting.photobucket.com/images/gg18/barry2952/IMG_3440.JPG